Resolve "Too Many IP Addresses" Error

The following article describes how to resolve the pop-up error in the Alert Logic console when you have too many IP addresses monitored by an appliance.

Solution

1. Attach a Monitoring Policy to the appliance that explicitly specifies a few CIDRs that cover your network (rather than having the back-end compose the home network out of every separate agent IP in the assignment policy).
   
   
2. Deploy more appliances and/or split their assignment policies, so that fewer hosts are assigned to each appliance. 
   
   Note: It does not suffice to add an appliance to an existing assignment policy, because homenet is determined per assignment policy, not per appliance.
   
   
3. Clean up any offline/dead agents still attached to the appliance by deleting PHost source.